Where a powered crimper cannot reach, the DZW-51CSD does. By replacing the electric motor with a lever-actuated hydraulic pump, Willex has engineered a machine that still delivers 1650 kN of crimping force — enough to form consistent, leak-free couplings on high-pressure braided and spiral hoses — while remaining fully independent of mains power. Its compact 550 × 550 × 500 mm frame and 165 kg net weight fit into a service vehicle or a one-bay workshop, and the ten included die sets (Nos. 15–63, with optional sizes available) cover the most common 1/4"–2" assemblies straight out of the crate.
| Crimping Range | 1/4"-2" | Crimping Force | 1650 KN |
|---|---|---|---|
| Maximum Open Diameter | 113mm | Max.Opening | ±30mm |
| Work Efficiency | 10pcs/h | Motor Power | Hand Pump |
| Machine Size | 550*550*500mm | Packing Size | 715*610*700mm |
| Net Weight | 165Kg | Gross Weight | 190Kg |
Dies No | Range(mm) | Length(mm) |
∅15 | 15-19 | 60 |
∅19 | 19-23 | 60 |
∅23 | 23-26 | 60 |
∅26 | 26-31 | 60 |
∅31 | 31-36 | 70 |
∅36 | 36-41 | 70 |
∅41 | 41-47 | 70 |
∅47 | 47-55 | 80 |
∅55 | 55-63 | 80 |
∅63 | 63-93 | 80 |
Runs fully on a hand-pumped hydraulic circuit, needing no mains power, compressed air, or external unit — ready for remote sites, service trucks, and field repair.
The relief valve stops the crimp automatically at a fixed pressure, so every closure hits the same diameter regardless of who pumps.
Ten included dies swap in seconds without tools, letting one technician move between hose sizes mid-job.
No motor, contacts, sensors, or valves to service — just oil checks and seal inspection, so downtime stays low.
The closed bench frame stays planted through full-force cycles and bolts straight onto a truck or small workshop floor.
The relief valve caps the crimp before dies or couplings can be crushed, extending tool life and protecting the operator.



The hydraulic circuit reaches a fixed pressure relief point and stops automatically, so die closure stays consistent from operator to operator regardless of lever effort.
The 1650 kN rating covers the full 1/4"–2" range and is suitable for standard 1-and-2-wire braided as well as 4-wire spiral assemblies within their working-pressure limits.
Ten pieces per hour is the sustained shop-floor average including normal die changes; on a single repeated size, operators typically run noticeably faster.
The die pockets follow the common industry profile, and the ten included numbers plus optional sizes cover your most-used couplings without locking you into a single supplier.
Maintenance stays simple — check the oil level, top up with standard ISO 46 anti-wear hydraulic oil, and inspect the seal set annually, with no brushes, contacts, or electronics to service.
The 550 × 550 × 500 mm frame is engineered for two-person carry or a pallet jack, which is why mobile service operators mount it permanently in hose-service trucks rather than relocating it daily.
If you are interested in our products, you can choose to leave your information here, and we will be in touch with you shortly.